Announcement

Collapse
No announcement yet.

Log Check Please - 2020 G70 AWD Sport

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Log Check Please - 2020 G70 AWD Sport

    Finally got to dyno my car. Looking for feedback on the logs & results. It sEeMs LoW, but I also assume that it was too hot out and our 91 pump is just lousy where I live (central Canada).
    Sent to [email protected] and got a lot of heatsoak warnings, as well as timing corrections. I've never not had timing corrections though on my gas here, even after switching from Denso to HKS plugs (gapped correctly).

    First dyno sheet is actuals, second dyno sheet is with +10% correction to match the other dynos in my city

    Dyno: DynoCom
    Environmental: 32c, 40% RH, 239m elevation above sea level
    First pull: Map 0, pump 91
    Second pull: Map 1, pump 91
    Third pull: Map 2, pump 91 + can of Boostane Premium
    Fourth pull: Map 3, pump 91 + Boostane
    Gave it a bit to cool down and added more fans to the front aimed at IC.
    Fifth pull: Map 3, pump 91 + Boostane

    Mods:
    AEM intakes
    Big air snorkels
    HKS sparks gapped
    JB4 with fuel and EWG wires
    Tork TCU flash (stage 1)
    Aftermarket *********, no 2nd cats, custom X midpipe, OEM mufflers (custom sections are 2.5", OEM is 2.25" I think?)

    Thanks in advance!
    Attached Files

  • #2
    Since it's not a dynojet the numbers don't mean much. Logs look pretty normal though. The 130f inlet temps are certainly holding power back a bit.
    Attached Files
    Burger Motorsports
    Home of the JB4 the worlds most popular turbocharged tuning system!

    It is the sole responsibility of the purchaser and installer of any BMS part to employ the correct installation techniques required to ensure the proper operation of BMS parts, and BMS disclaims any and all liability for any part failure due to improper installation or use. It is the sole responsibility of the customer to verify that the use of their vehicle and items purchased comply with federal, state and local regulations. BMS claims no legal federal, state or local certification concerning pollution controlled motor vehicles or mandated emissions requirements. BMS products labeled for use only in competition racing vehicles may only be used on competition racing vehicles operated exclusively on a closed course in conjunction with a sanctioned racing event, in accordance with all federal and state laws, and may never be operated on public roads/highways. Please click here for more information on legal requirements related to use of BMS parts.

    Comment


    • #3
      Based off of what you're seeing Terry, would you run Map 2 on my 91 pump without boostane? Or nah

      Comment


      • #4
        Its probably fine, log it on map2 with 91 and lets see.
        Burger Motorsports
        Home of the JB4 the worlds most popular turbocharged tuning system!

        It is the sole responsibility of the purchaser and installer of any BMS part to employ the correct installation techniques required to ensure the proper operation of BMS parts, and BMS disclaims any and all liability for any part failure due to improper installation or use. It is the sole responsibility of the customer to verify that the use of their vehicle and items purchased comply with federal, state and local regulations. BMS claims no legal federal, state or local certification concerning pollution controlled motor vehicles or mandated emissions requirements. BMS products labeled for use only in competition racing vehicles may only be used on competition racing vehicles operated exclusively on a closed course in conjunction with a sanctioned racing event, in accordance with all federal and state laws, and may never be operated on public roads/highways. Please click here for more information on legal requirements related to use of BMS parts.

        Comment


        • #5
          Will do after this tank is finished since it has Boostane in it! Thanks again Terry

          Comment

          Working...
          X