No announcement yet.

2023 G70 2.0 M1/M2 log check

  • Filter
  • Time
  • Show
Clear All
new posts

  • 2023 G70 2.0 M1/M2 log check

    Hello all,

    2023 G70 2.0 AWD
    HKS Plugs (m45xl) gapped 0.28 (The pre-gapping was all over the place, I adjusted. Now all really close to 0.28) tightened using 17lbs torque. Coil packs at 10lbs
    93 Octane (pump)
    No other mods on car (1,200 miles on car Odo)

    I’ve recently installed the JB4 and HKS plugs. This was my first run on M2. Three total logs in this file. One on M1 and two on M2 (last log was getting on freeway 100mph+)
    Just wondering what any of the pros here think of the logs. Anything I should watch out for or keep an eye on? I know there’s some timing on 2-4, anything about that abnormal for my setup?

    Thanks in advance for anybody's time spent replying. I appreciate any input. Thanks again!
    Attached Files

  • #2
    Looks pretty normal to me for a 2L on 93 octane, map2.
    Attached Files
    Burger Motorsports
    Home of the JB4 the worlds most popular turbocharged tuning system!

    It is the sole responsibility of the purchaser and installer of any BMS part to employ the correct installation techniques required to ensure the proper operation of BMS parts, and BMS disclaims any and all liability for any part failure due to improper installation or use. It is the sole responsibility of the customer to verify that the use of their vehicle and items purchased comply with federal, state and local regulations. BMS claims no legal federal, state or local certification concerning pollution controlled motor vehicles or mandated emissions requirements. BMS products labeled for use only in competition racing vehicles may only be used on competition racing vehicles operated exclusively on a closed course in conjunction with a sanctioned racing event, in accordance with all federal and state laws, and may never be operated on public roads/highways. Please click here for more information on legal requirements related to use of BMS parts.


    • #3
      Thank you, Terry!