Tweet
What could be a reason for high trims? I have ran Mao 3 once with E30. Timing was pretty good, but under WOT trims were 50 plus. I checked my AFR and it was a little lean but not too bad. Probably about 12 to 12.2.
Thanks
Thanks
-
-
No problem, you are just starting to max out your fueling capabilities with E30 and that power level. As long as AFR's are good, the car's good!
Just make sure to keep an eye on your AFR's if you head into a cooler climate as the fuel demand will increase and you may go lean.Burger Motorsports
Home of the JB4 the worlds most popular turbocharged tuning system!
It is the sole responsibility of the purchaser and installer of any BMS part to employ the correct installation techniques required to ensure the proper operation of BMS parts, and BMS disclaims any and all liability for any part failure due to improper installation or use. It is the sole responsibility of the customer to verify that the use of their vehicle and items purchased comply with federal, state and local regulations. BMS claims no legal federal, state or local certification concerning pollution controlled motor vehicles or mandated emissions requirements. BMS products labeled for use only in competition racing vehicles may only be used on competition racing vehicles operated exclusively on a closed course in conjunction with a sanctioned racing event, in accordance with all federal and state laws, and may never be operated on public roads/highways. Please click here for more information on legal requirements related to use of BMS parts. -
Throw up the log if you want us to check it out. Trims will be high during spool up and should drop down towards 25 (0%) during longer runs.Burger Motorsports
Home of the JB4 the worlds most popular turbocharged tuning system!
It is the sole responsibility of the purchaser and installer of any BMS part to employ the correct installation techniques required to ensure the proper operation of BMS parts, and BMS disclaims any and all liability for any part failure due to improper installation or use. It is the sole responsibility of the customer to verify that the use of their vehicle and items purchased comply with federal, state and local regulations. BMS claims no legal federal, state or local certification concerning pollution controlled motor vehicles or mandated emissions requirements. BMS products labeled for use only in competition racing vehicles may only be used on competition racing vehicles operated exclusively on a closed course in conjunction with a sanctioned racing event, in accordance with all federal and state laws, and may never be operated on public roads/highways. Please click here for more information on legal requirements related to use of BMS parts.Comment
-
Here is a log from a while back, i know my FF and WGDC are a little off and have since added EWG wires to correct.
So, would a high trim number under WOT essentially mean my E30 mix may be a little lean on ethanol? I don't have the flex it kit, so I mixed 4 gallons of E85 in a full tank. Thanks!Comment
-
Trims are higher than normal, I'd guess it's more than an E30 mix based on the trims. But AFR is stable so I don't think its an issue.Attached FilesBurger Motorsports
Home of the JB4 the worlds most popular turbocharged tuning system!
It is the sole responsibility of the purchaser and installer of any BMS part to employ the correct installation techniques required to ensure the proper operation of BMS parts, and BMS disclaims any and all liability for any part failure due to improper installation or use. It is the sole responsibility of the customer to verify that the use of their vehicle and items purchased comply with federal, state and local regulations. BMS claims no legal federal, state or local certification concerning pollution controlled motor vehicles or mandated emissions requirements. BMS products labeled for use only in competition racing vehicles may only be used on competition racing vehicles operated exclusively on a closed course in conjunction with a sanctioned racing event, in accordance with all federal and state laws, and may never be operated on public roads/highways. Please click here for more information on legal requirements related to use of BMS parts.Comment
-
Comment