Tweet
I think I uploaded the correct log, but when pushing hard I am getting a stutter / hesitation, significantly between 1st gear & 2nd. Does this log show an issue? (Map 6) I also am wondering, how can I tell if my CPI installation is working correctly as it should be? I had an issue with the install previously where my E85 reading wasn't working, and had to get that fixed, so I want to make sure nothing else was missed and all installed correctly and working correctly. Thanks so much for your help.
-
Last edited by Stinger919; 03-02-2023, 08:59 AM. -
Even with the issues, I did do one 0-60 run at a 3.98...Attached Files -
-
This need to be put in the correct section for feedback. I'll move it.
Click on our banner to visit our website!
Video of our Stage 2 LPFP upgrade installation.
BMS products labeled for use only in competition racing vehicles may only be used on competition racing vehicles operated exclusively on a closed course in conjunction with a sanctioned racing event, in accordance with all federal and state laws, and may never be operated on public roads/highways.Comment
-
-
No help / input form anyone? Asking b/c I've seen newer posts get responses, but nothing here yet. Thanks again for any info/help.
'19 GT2 AWD
BMS intercooler
Flex Fuel / CPI kit
EWG wires
Ultimate Performance HFC primary and secondary *********
MBRP Catback
Comment
-
Why is map6 set to 0psi? What are you trying to do here exactly?
CPI volume is too high for the boost level.
Load the default CPI profile and log map3.Attached FilesBurger Motorsports
Home of the JB4 the worlds most popular turbocharged tuning system!
It is the sole responsibility of the purchaser and installer of any BMS part to employ the correct installation techniques required to ensure the proper operation of BMS parts, and BMS disclaims any and all liability for any part failure due to improper installation or use. It is the sole responsibility of the customer to verify that the use of their vehicle and items purchased comply with federal, state and local regulations. BMS claims no legal federal, state or local certification concerning pollution controlled motor vehicles or mandated emissions requirements. BMS products labeled for use only in competition racing vehicles may only be used on competition racing vehicles operated exclusively on a closed course in conjunction with a sanctioned racing event, in accordance with all federal and state laws, and may never be operated on public roads/highways. Please click here for more information on legal requirements related to use of BMS parts.Comment
-
-
Hmmm...The CPI and all the settings should have been set up based on the instructions with the install. Not sure why something maybe off or not correct. I will need to research and look up how to do what you mentioned. And I also was pretty sure I read to set up the CPI configuration on map 6? Still learning....
Thanks so much for your help 🙏🏼Comment
-
Terry @ BMS late reply, but I went back and double checked every setting and compared it to the instructions for the charge pipe injection install, and everything is set exactly as the screen shots show in the instructions. I opened map 6, and I went to the settings. I am not sure what screenshot you attached, but those are not the settings I see. I'll just upload some new logs soon to get a fresh look at whatever I have going onComment
Comment