Wrong platform...no need to push start/stop 3 times quickly on S55.
I have had issue with my M2 (although a 2020) deleting codes but the...
Steve @ BMS/Fuel-It!
Tuner
Last Activity: Yesterday, 09:59 PM
Joined: 10-15-2012
-
No problem, so far so good...try setting FF to 100 and do another log on map 4.Leave a comment:
-
I prefer smaller nozzles like BM5 and BM7 so dual nozzles is better IMO. Or do DPMI (Direct port meth injection, better volume and distribution.Leave a comment:
-
Can you do a decent log on map 1? Best to start there as these pulls are only from 1-2K rpms. Start at 2K in 3rd and take it to redline at WOT on a...Leave a comment:
-
Try resetting your lambda adaptions and see if it corrects the issue. Then if it walks its way back out, it's likely an O2 sensor issue.Leave a comment:
-
Leave a comment:
-
Timing is getting better, see how map 4 looks.Leave a comment:
-
It affects all maps.Leave a comment:
-
Bank 1 AFR's are wonky. Where's your map 1 log?Leave a comment:
-
You may have swapped bank 1 and 2 primary sensors...that would cause an issue like this.Leave a comment:
-
Yes, you are in open loop and it will change the exhaust tone. You can reset your lambda adaptions and see what it does.Leave a comment:
-
How about 1 good recent log to evaluate?
Do a log on a private track starting in 3rd gear at 2k rpms, go WOT and hold it until red line...Leave a comment:
-
Logs from a dig aren't very good for analysis or adaptions.
Timing is poor...how does map 1 look?Leave a comment:
-
Are you on the stock flash? Timing is poor, what fuel are you running?Leave a comment:
-
Log looks pretty normal...stock turbo is maxed out.Leave a comment:
-
You can stick with the E85 flash for hybrid turbos and take a log. I'd recommend running map 5 next and map 3 when you get meth installed.Leave a comment:
-
You need to post in the Infiniti section and post a log...the actual CSV file will have everything we need.Leave a comment:
-
Not the greatest of logs but looks pretty normal otherwise. Some slight timing corrections but not bad.
Try a log starting in 3rd at about...Leave a comment:
-
Leave a comment:
-
You have a 4 bar tmap installed? TMAP is set to 2.Leave a comment:
No activity results to display
Leave a comment: